Blog.gowifi

Blog.gowifi

logos (other)

Logos

Go Wireless NZ

Follow by Email

Thursday, July 11, 2013

Ubiquiti Wireless Point to Multipoint Network


Scenario:
This article explains how to create a Ubiquiti Point to Multipoint Wireless Network. This configuration requires completion of the Ubiquiti Point to Point WDS Bridge before continuing.


Step 1:
Connect the NSM5 (Station) to your laptop or network and navigate to the Wireless tab.
Wireless Mode: Station
WDS (Transparent Bridge Mode): Enable
Channel Width: 30 MHz
Select Change and Apply settings.
Step 2:
Click the Select button next to the SSID field.
Click the radio button next to your SSID (my_wds_bridge) and the press Select.
Enter WPA Preshared Key: mys3curek3y123
Select Change but do not Apply settings yet.

Step 3:
On the Network tab make the following changes.
IP Address: 192.168.1.202
Netmask: 255.255.255.0
Gateway IP: 192.168.1.1
Primary DNS IP: 192.168.1.1
Select Change but do not Apply settings yet. 

Step 4:
On the System tab change the following.
Device Name: NSM5-ST (Optional)
Time Zone: (GMT+12:00) Auckland, Wellington, Fiji, Kamchatka (Optional)
Administrator Username: admin (Optional)
Current Password: ubnt (Optional)
New Password: mys3cr3t (Optional)
Select Change and Apply settings.
Step 5:
Verify the Station configured and connected successfully by logging into the main Access Point the station is connecting to and checking the connection status on the Main tab.

No comments:

Post a Comment